Impressive Tips About How To Lower Your Street Bike

You may have to register before you can post:

How to lower your street bike. Remove the old bolts or screws. You can use a punch tool or a shock punch to turn the preload adjuster ring. This will make it more.

Next, use the adjustable wrench or socket set to. The first step is to remove the seat and gas tank so that you have easy access to the shock absorbers. In general, most current dirt motorcycles have an initial leverage ratio ranging from 3.1 to 4.0, with the exception of a few exceptions.

Tightening it will compress the spring and lower the bike’s resting position. Gather up your tools and go for a walk to where you need to do this. When using a 3mm spacer, the rear end will.

You can also adjust the preload on your existing shocks to. You can shorten these spacers by a few inches, which will drop the bike by as much as an inch and a half. Consequently, there's not an easy way to shorten it.

Lower the suspension remove all body panels and the seat. Just get her a predator seat from drag specialties, that will drop her down quite a bit. Another way to lower a bike is by lowering the seat.

If the design allows, you can slide the forks up in the triple trees; Streetbob's already have low ground clearance, hate to see someone sliding on the primary. One option is to install shorter shocks.

Remove the seat and tank. Click the register link above to proceed. All of which are a better alternative to lowering the bike and much less expensive with no ill effects.

This is probably the easiest way to lower your bike without making any permanent changes. If this is your first visit, be sure to check out the faq by clicking the link above. Make sure, however, the fender doesn't hit the triple tree.

Loosen the fork pinch bolts.